+16 – 30V dc
+16 – 30V dc
POWER
1
+
–
+
–
16-30V dc
1 A max
10-30V dc
GATE
SIGNAL
4-20 mA
ANALOG
OUTPUT #1
4-20 mA
ANALOG
OUTPUT #2
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
F1
BROWN
BLUE
DRAIN
(BARE)
BLACK
WHITE
EMITTER and
RECEIVER CABLES
DISCRETE
OUTPUT#2 (ALARM)
+
–
10-30V dc
ALIGN
Load
Load
150 mA
max
DISCRETE
OUTPUT#1
150 mA
max
TX
TX
RS-485
Figure 10. MAHCIP-1 Wiring
3.3.1 Emitter and Receiver Wiring
Connect emitters and receivers together in parallel to terminals #4 through #8 of the control module (identical for all control
module models). See the figures in
(p. 9) for wire color information.
Trim braided shield flush
with cable
Trim foil shield flush
with cable
Uninsulated
drain wire
Note: The “drain wire” is the
uninsulated stranded wire which runs
between the braided shield and the
foil shield. The foil shield and the
braided shield should be removed at
the point where the wires exit the
cable.
Figure 11. Emitter and Receiver Cable Preparation
3.3.2 Inputs
System Power: Connect a source of 16 V dc to 30 V dc, rated at 1 amp or greater, to control module terminals #1 (+) and #2
(-). Connect a good earth ground to terminal #3 to provide electrical and RF noise immunity to the System.
Note: Remove power before making other connections to the controller.
Gate Signal: A source of 10 V dc to 30 V dc switched to terminals #12(+) and #13(-) provides a gating input (if required). The
gating voltage typically is switched by the open-collector output transistor of a dc sensing device. The gate signal controls
scanning when one of four Gate options is selected in the Control Mode Selection menu of the PSF configuration routine
(see
(p. 19)) .
Align: A source of 10 V dc to 30 V dc switched to terminals #14(+) and #15(-) provides a remote means of running the
(p. 14) for the Alignment switch on the front of the control module.
A-GAGE
®
High-Resolution MINI-ARRAY
®
10
www.bannerengineering.com - Tel: + 1 888 373 6767