97282 v.3.0
15
13.
Secure the Derringer harness to
the factory drip tray at the top of the
firewall. Run the harness towards the
driver’s side fender and secure using
the supplied zip ties. See
Figure 12
.
Secure the EGT branch of the harness
away from hot exhaust components.
14.
Connect the Derringer module to
the sensor harness and then connect
it to the Derringer Starter Cable. If
using the 3-position switch, on a Ram
1500 install the
gray Dust Cap
on the
Derringer. If using the 3 position switch
on a Jeep Grand Cherokee or when
using a iDash 1.8, install the
black
Terminator Cap
. Once the correct
cap is in place rotate the locking ring
clockwise to secure the cap. Then
locate a place to secure the Derringer
module, along the driver’s side fender,
and tie-wrap it in place.
If installing in a Jeep
Grand Cherokee, skip steps 15-17 and
proceed to step 18.
Jeep Grand Cherokee
requires the use of black Terminator
Cap at all times.
Once the correct cap is in place
rotate the locking ring clockwise to
secure the cap. Then locate a place
to secure the Derringer module, along
the driver’s side fender, and tie-wrap
it in place. If installing in a Jeep Grand
Cherokee, skip steps 15-17 and
proceed to step 18.
Figure 12
