14
97282 v.3.0
Grand Cherokee – EGT Intercept
Remove underbody tray beneath the
transmission. Locate the harness
that runs along the driver side of the
transmission. See
Figure 10.
Trace the EGT sensor connector branch
of the harness. (Thinner branch at the
harness split) See
Figure 11
.
Unsecure the EGT harness branch
from a tie down located above
the transmission. Unlock the EGT
connector by sliding the yellow
connector lock, and disconnect the
factory EGT Connection.
Route the EGT branch of the Derringer
harness along the driver side firewall.
Ensure the harness is away from the
exhaust manifold and secure the
harness.
12.
Connect the female factory EGT
connector to the male connector on
the Derringer harness and the male
factory connector to the female
connector on the Derringer harness.
Ensure that the connector locks are
fully engaged. Confirm the connections
are secure by tugging firmly on both
sides of the connection. Do not pull
on the wires but only the plastic
connectors. If the connector was
removed from its mounting tab, reinstall
the connector on the mounting tab.
Figure 10
Figure 11
Grand Cherokee
Grand Cherokee
