Bang & Olufsen BeoSound Moment, Руководство по установке

Страница: 53 / 70

ServiceTool Use - connect to SoundHeart 53
Use of ServiceTool
The ServiceTool is primarily used with service and repair situations, when replacing the Main Processor board of the BeoSound Moment hub
(SoundHeart) and replacing the Wireless Power Link Tx board.
The ServiceTool is also used when the BeoSound Moment interface (Jukebox) is replaced.
In an installation situation the ServiceTool may also be used for SW update; see .
In the following connecting the ServiceTool (computer) and the BeoSound Moment hub (SoundHeart) and the BeoSound Moment interface
(Jukebox) as well as all functions available are described.
It is very important that the product is updated to the latest software version before it is returned to the customer. This is to ensure the customer
receives the best possible experience.
The ServiceTool (computer) should first be started.
- Click on the PRODUCT tab (if not already shown).
Be sure that ServiceTool is updated to the latest version. If not, upgrade and restart ServiceTool.
- Scroll down to BeoSound section.
- Select
BeoSound Moment and click Launch .
- Click + next to each item to expand the menus.
- Make sure the ServiceTool (computer) is connected to the same wireless home router/AP as the BeoSound Moment.
Connect ServiceTool computer to BeoSound Moment hub (SoundHeart)
- Open the SoundHeart > System Info menu and read instructions on how to connect the ServiceTool to the product.
The computer running the ServiceTool can connect to the BeoSound Moment in two ways, as follows:
- Wireless connection
- Connect computer to the same home router/AP as the BeoSound Moment.
- In the bottom bar to the left, select the network adaptor used.
- Press the
Discover
button. If only one device is found it is selected automatically and if more products are found select the BeoSound Moment
from the drop-down list. The IP address is displayed automatically.
Alternatively the IP address can be entered manually.
- Press the
Connect
button. IP address is automatically displayed and connection is being established.