B&C Technologies SI Series, Инструкция по установке и эксплуатации

Страница: 47 / 55

(b) Close the door without locking it and attempt to start the machine. The machine should
not start with the door open.
(c) Close and lock the door and start a cycle. Attempt to open the door while the cycle is
in progress. The door should not open. If manual latch is moved out of position the
machine should stop.
If the door lock and interlock are not functioning properly, call a service technician.
7.1.2 End of Day
1. Clean the door gasket of residual detergent and foreign matters.
2. Clean the automatic supply dispenser and the lid inside and out with mild detergent. Rinse
with clean water.
3. Clean the washers top, front and side panels with mild detergent. Rinse with clean water.
4. Leave loading door open at the end of each day to allow moisture to evaporate.
NOTE: Leave loading door open at end of each complete cycle to allow moisture to evaporate.
Unload the machine promptly after each completed cycle to prevent moisture build up.
7.2 Weekly
1. Check the machine for leaks.
(a) Start an unloaded cycle to fill the machine.
(b) Verify that door and door gasket do not leak.
(c) Verify that the drain valve is operating. If water does not leak out during the prewash
segment, drain valve is closed and functioning properly.
2. Clean the AC drive box air filters.
(a) Snap off the external plastic cover which contains the filter. Remove the foam filter from
the cover.
(b) Wash the filter in a mild soap solution or vacuum it clean. Replace if damaged. Operat-
ing the machine without filter will cause premature inverter failure.
7.3 Monthly
NOTE: Disconnect power to the machine at its source before performing the monthly mainte-
nance procedures.
43