24
232XSSD43800 Manual
B&B Electronics -- PO Box 1040 -- Ottawa, IL 61350
PH (815) 433-5100 -- FAX (815) 433-5104
If the software was installed on your hard drive follow these
steps:
•
Type C: and press the ENTER key.
•
Type CD\XSS and press the ENTER key.
Or if you are going to execute XSSTSR.COM from the floppy drive
follow these steps:
•
Place the “DOS” disk in drive A.
•
Type A: and press the ENTER key.
To begin the XSSTSR program (the following will be used as an
example):
Port Address = 03F8
Parity = Odd
Baud = 9600
User Defined Char. = 8
Data Bits = 8
Command String = 0
Hot Key Sequence = 4
•
Type XSSTSR A03F8 B7 D8 P1 U8 C0 H4 and press the
ENTER key.
Using this method, every time you want to install the XSSTSR
with different parameter settings than the default (refer to the Default
Values section), the missing parameter must be specified.
Parameters
The Port Address is the address where the serial
communications port is located. If this is unknown you can use the
program PORTFIND.EXE which is located on the disk. To use
PORTFIND.EXE:
If you installed the software on your hard drive (see the
Installation section):
•
Type C: and press the ENTER key.
•
Type CD\XSS and press the ENTER key.
•
Type PORTFIND and press the ENTER key.
