UL4000-D
ULTRA-LOK® TOOL
BAND-IT IDEX, Inc.
Document # P09986 Rev. B
A Unit of IDEX Corporation
© Copyright
4799 Dahlia Street
www.BAND-IT-IDEX.com
BAND-IT IDEX, Inc. 2016
Denver, CO 80216-0307 USA
All Rights Reserved
P: 1-800-525-0758
F: 1-800-624-3925
15
Blade Change: Optional ½” Tool
To change out the tool to the 1/2" version, the following steps should be followed.
*
NOTE:
Do not attempt to use 1/2" clamps with 3/4" head. (Shear Plate change-out: 3-5 minutes)
1. Prior to separation from power drill, back off Tension Block assembly 1/2" from head unit. See page 7 Figure 4.
2. Detach Tension Body from the Drill by loosening the single tensioning bolt on the aluminum collar and separating
the two sections.
3. Remove the Blade from head by removing the two Cap Screws (M05787) from the top of the Head. It is not
necessary to remove entire head from tool in order to remove blade. (Figure 13) Remove the 3/4" shear plate from
the blade.
4. Align the 1/2" Shear Plate (M09387) with the Blade (M09787) so that the guide is facing up. Incorrect placement
will not allow bands to be inserted into the Tool. (Figure 13)
Note: To convert Tool back to 3/4", replace 1/2" Shear Plate with 3/4" Shear Plate (M09887) and follow same
instructions. Be sure to retain unused Shear Plate for later use.
5. Attach the Blade and 1/2" Shear Plate onto Head using the two previously removed Cap Screws. These Cap
Screws must be tight to assure proper cut-off of clamp tails.
6. Re-attach Drill to Tension Body making sure the Drill and Tension Body are properly aligned, and tighten the single
Blade Cap Screw located on the Adapter Collar.
7.
These tools are
NOT designed to work with traditional band and buckle designs
. BAND-IT Ultra-Lok
clamps must be used.
Optional 1/2" Shear
Plate (M09387)
Orient as shown
Blade (M09787)
Blade Cap Screw
(M05787) Qty. 2
1/4" Ball (M06587)
Bearing Tip (M05387)
Blade (M09787)
Figure 14
Figure 13