UL4000-D
ULTRA-LOK® TOOL
BAND-IT IDEX, Inc.
Document # P09986 Rev. B
A Unit of IDEX Corporation
© Copyright
4799 Dahlia Street
www.BAND-IT-IDEX.com
BAND-IT IDEX, Inc. 2016
Denver, CO 80216-0307 USA
All Rights Reserved
P: 1-800-525-0758
F: 1-800-624-3925
14
5. To replace Gripper: Make sure Tension Block is all the way forward against the tool head. Remove drill. Remove
tool adapter body. Remove one side of the tool body or the other, not both. Slide Gripper out sideways and
replace with a new one. Re-attach Tool Body side.
Caution:
Do not push or move Tension Block while Gripper is
out of tool.
Tension
Screw
M00987
Move tension
block all the way
forward against
the tool head
Tool Head
M00587
Gripper
M08887
Screw, #10-32
M06187
Figure 12
6. To replace Tension Screw: Move Tension Block all the way back (away from Tool Head) using drill in tensioning
mode (clock-wise). Remove Ultra-Lok
Tool from Drill. Remove the Tool Adapter from the Ultra-Lok
Tool.
Remove Blade and load bearing tip from Tensioning Screw (see bearing detail). Remove one side of the Tool
Body or the other, not both. Grasp the smooth barrel on Tension Screw and pull all the way forward until Tension
Block is against the Tool Head. If Tension Screw is stuck, use a punch and tap the center of the screw from the
back end of the tool. Turn Tension Screw out of Tension Block. Lubricate new Tension Screw with Molybdenum
Disulfide lubricant, or equivalent. Install new Tension Screw in reverse order; making sure that back end of
Tension Screw extends well beyond the back end of the Tension Block. Push the assembly all the way back and
extend the round portion of the Tension Screw through holes on the tripper bracket and back guide plate. Reinstall
Tool Body side. Reinstall Blade and tighten the Blade Mounting Screws approximately 120 in-lbs. Reattach Tool
Adapter to Ultra-Lok
Tool. Reattach Tool to Drill and drive Tension Block all the way forward.
Note: Drills needing repair must be returned to Band-It.
