UL4000-D
ULTRA-LOK® TOOL
BAND-IT IDEX, Inc.
Document # P09986 Rev. B
A Unit of IDEX Corporation
© Copyright
4799 Dahlia Street
www.BAND-IT-IDEX.com
BAND-IT IDEX, Inc. 2016
Denver, CO 80216-0307 USA
All Rights Reserved
P: 1-800-525-0758
F: 1-800-624-3925
11
Clamp Inspection
Lock sheared in center
and formed inside
shroud
Section View
Good Clamp
Inspect buckle on the completed clamp and tap down the buckle shroud
FRONT VIEW
Completed Free-End Clamp
(Visually inspect lock)
Buckle Shroud
Shear Surface
Bad Clamp
Lock has slipped back
under sheared buckle
surface
Figure 7
Important:
Visually inspect lock formed in band as shown. If lock has slipped under the sheared surface of the
buckle, remove clamp and install a new one at reduced tension by lowering the Drill Clutch torque setting.
SIDE VIEW
Completed Free-End
Clamp
Tap down buckle shroud to
complete clamp
Figure 8