26
User Manual
IT8000 3/8” TIE
-LOK DATA TOOL
IT7000 1/4” TIE
-LOK DATA TOOL
ITC800 CONTROL SYSTEM
Document # P80080 Rev. C.3
© Copyright
BAND-IT-IDEX, Inc. 2024
All rights reserved
All rights reserved
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
Figure 44
TOOL ROTATION
The tool may have to rotate in all three axes of rotation depending on the application (Fig. 44).
Pitch
is required for all setups, as this rotation is required to ensure the buckle
is installed tangent to the work piece. A minimum of 30° of rotation is required
for the tool to operate, but 120° is recommended. The tool should be allowed
to rotate both forwards and backwards from the tangent point the buckle is
expected to be placed. See Figure 43 for the minimum rotation away from the
buckle.
Yaw
is typically required if the tool is installing more than one clamp, especially
if the tool is on a swing arm or articulating arm. 180° of rotation is
recommended, 90° in each direction from straight on.
Roll
is required on applications that have clamp(s) at different angles. Depending on the application, 90° of
rotation is recommended.
Yaw
Roll
Pitch
Figure 43