Bambi MAX BBXHL4000, Руководство по обслуживанию

Страница: 48 / 91

Section 8: Repairs
Bambi MAX Service Manual
– Models HL4000-HL9800 43
3. Loosen the two tension clamps and lower the clamps
into the position shown in this picture.
4. Remove the seal and clean any debris from the bottom
of the tube and groove.
5. Install the replacement seal over the valve tube and
move the clamp into position. Make sure that the
tensioner clamps are located between the lift bar
bolts.
6. Tighten the tensioner clamps. Make sure to tighten
each clamp equally as this will eliminate a problem
of the clamp releasing as one of the tensioners is not
engaged enough to hold the clamp.
When the valve is closed, ensure no light is passing between the bottom seal and base ring. If light is
passing through in a specific area, loosen the tensioner clamp and push the seal down in the specific area,
then tighten the clamp ring. Repeat until light is no longer visible.
Top Seal Replacement
To change the top seal, the valve does not need to be removed from the shell.
To remove the valve, please refer to the valve removal section in the maintenance section of this manual.
Once the valve has been removed, follow the directions below.
Tools required: Allen key 1/8"
1. To replace the top seal with the valve still in the
bucket, first detach the control cable from the head
and the IDS deployment cable and hub. Coil the cable
up and place it inside the top of the shell.