Ballu Plaza Ext Series, Руководство по эксплуатации

Страница: 8 / 16

8 Safety measures
Prior to cleaning disconnect the heater from the mains.
Loosen the spacer screws on the latches. Lower two
latches «Р» (see Fig. 6) on the rear panel of the heater
and pull the device to yourself. Remove the device
from the brackets and clean the rear panel. After
cleaning the heater should be mounted in the reverse
order.
Safety measures
•
Fix the heater reliably on the wall or place it in the
correct position.
•
The heater should be installed in such a way so
that a person in the bath or shower could not
accidentally touch the control panel.
•
It is forbidden to place the heater under the
mains socket.
•
If the heater is placed on the floor, keep it away
from the bath, shower or swimming pool.
•
If wall-mounted, never locate the heater in the
vicinity of the bath, shower or the swimming pool.
•
If the power cable is damaged, contact a qualified
electrician or a service person.
•
NEVER cover the working heater.
•
Before storage arrangements ensure the heater is
cool.
•
If the heater is not intended for use for a long
time it is recommended to clean it and put for
storage (preferably in the factory package) in a
cool dry place.
Maintenance
If maintenance is necessary, contact the authorized
service center.
Power cable replacement
To avoid accidents the damaged power cable should
be replaced by the service centre representative or
another qualified specialist.
Installation
1. Wall mount. Install the heater on the wall near the
floor using the brackets according to the figures below.
The distance from the device to the floor should be at
least 10 cm.
Fig. 7
The wall bracket can be released from the convector as
follows:
•
press the latches and pull the bracket to yourself;
•
mark and drill the holes;
• install the bracket on the wall and fix it.
Fig. 8