Ballu Plaza Ext Series, Руководство по эксплуатации

Страница: 6 / 16

6 Technical specifications
Technical specifications
Part No. ВЕР/ЕХТ-1000 ВЕР/ЕХТ-1500 ВЕР/ЕХТ-2000
Heating power I, W 500 750 1000
Heating power II, W 1000 1500 2000
Rated watts input I, kW 0.5 0.75 1.0
Rated watts input II, kW 1.0 1.5 2.0
Rated voltage, V ~ Hz 220-240 ~ 50 220-240 ~ 50 220-240 ~ 50
Rated current, A 4.3 6.5 8.7
Protection class, IP ІР 24 ІР 24 ІР 24
Electrical protection class I class I class I class
Heated area, m
2
up to 15 up to 20 up to 25
Dimensions (WхHхD), mm 480x415x111 640x415x111 800x415x111
Dimensions of package (WxHxD), mm 575x470x142 735x470x142 895x470x142
Net weight, kg 5.78 6.63 7.48
Gross weight, kg 7.08 8.1 9.12
* Approximate heated area is specified.
The value may vary depending on actual operating conditions.
Operation
Preparation for operation
Carefully remove the heater out of the cardboard box.
Keep the box for out-of-season storage. Prior to
switching the convector heater on ensure it is in OFF
state. Install the heater following the installation
instructions. To avoid overloading of the mains it is not
recommended to connect the heater to a socket with
other high-power electrical appliances connected.
Switching the device ON
Plug the Timer into this socket. First press the power
button to turn the device on; at the switched off
timer on the display located on the front panel of the
device the room temperature will be displayed. The
factory preset temperature is 24°С.
'Comfortable' mode setting
This is the operational mode with the temperature set
by the user. This mode activates automatically unless
another mode is set. The factory temperature setting is
24°С.
Press the buttons and to increase the
temperature by 1°С or decrease by 1°С. The maximal
possible temperature is 35°С, the minimal - 5°С. If you
hold pressed the button
or the temperature
will be increased or decreased by 1°С per 0.5 s. The last
temperature setting is taken as active. In 5 s the system
will resume operation; the temperature indicator on the
display will stop flashing, and the room temperature will
be displayed.
'Anti-freeze' mode setting
To set the mode press the... button the indication
will appear on the front panel of the device. The
temperature +5°С will be set. To exit the mode press
again . The indicator will be off.
Timer setting
Press the button to set the timer; the set time is
indicated on the