Ballu KF-25GWE, Руководство по обслуживанию

Страница: 32 / 63

7.CONTROL MODE
1.1 Hold down the temporary switch and then turn on the air conditioner, the buzzer on the indoor unit rings two
times, and the unit enters in the self-test status.
1.2 If a signal has been received from the remote controller during the temporary run, the system will operate
according to the commands of the remote signal.
2. Automatic mode
3.1 When the remote controller is set to start the unit in the automatic mode, the air conditioner judges according to the
differences between the room temperature and temperature setting and selects a run mode.
Indoor temperature temperature setting, the unit runs in the cooling mode;
Indoor temperature temperature setting, the unit runs in the heating mode.
3.2 The run mode is determined when the unit gets started at the first time. Once a mode is selected, it will not change
within 30 minutes.
3.3 If the difference between the room temperature and temperature setting is above 3 , the run mode can be changed
immediately.
3.4 When the unit is turned off and restarted with the remote controller, these conditions remain valid.
3.5 When powered off and powered on again, the air conditioner will reselect a run mode.
3.6 The indoor and outdoor fan speed and compressor control in the automatic mode are same as that in the heating
and cooling mode.
3.7 After being set to the cooling only type in EE, the heating mode does not work.
4 Cooling mode
4.1 In the cooling mode, the temperature setting is selected by using the remote controller. The temperature control
ranges from 16-30
.
4.2 When powered on for the first time, the compressor can be started immediately. After turning off, the compressor
must not be restarted until at least 3 minutes later.
4.3 After turning on, the compressor must run for at least 5 minutes.
31
°Ñ
°Ñ