Ballu BHG-10, Руководство по эксплуатации

Страница: 8 / 38

8
for each 1 kW there should be
1 liter of gas, therefore, 10 liters
of 10 liters of liquefied gas, 15
kW need 15 liters of liquefied
gas, etc.
Appliance design
Execution of the heater: portable, working position
- installation on a horizontal flat surface.
Appliance control
1 2 4
5
3
2 4
5
1
1. Piezo igniter
2. Switch
3. Gas regulator
4. Gas valve
5. Nipple
Preparation for operation
1. Remove the heat source from the packaging. In
case of staying in the cold, the heat generator
Appliance design
service technician.
• For safety reasons, always
disconnect the plug from the
outlet before disassembling the
heat generator, maintenance or
when the heat generator is not
in use.
• When installing industrial gas
heat generators, observe the
rules and regulations for the
installation of similar equipment
in your area.
• Gas cylinders with propane
should be installed and
replaced where no ignition
sources are present.
• Use only special cylinders
for liquefied gas (propane,
propane - butane).
• Sometimes the cylinder can
be covered with hoarfrost,
i.e. to freeze. This situation
usually occurs when there is
not enough gas in the tank.
To reduce the likelihood of the
appearance of the effect of
"freezing" the gas cylinder, it is
recommended to work with the
minimum necessary gas flow.
There is an unspoken rule that