Baldor NextMove ST, Руководство по установке

Страница: 40 / 72

www.supportme.net
4-24 Input / Output MN1929
Note: All CAN related MintMT keywords are referenced to either CANopen or Baldor
CAN using the ‘bus’ dot parameter. Although the NextMove ST has a single
physical CAN bus channel that may be used to carry either protocol, MintMT
distinguishes between the protocols with the ‘bus’ dot parameter. For CANopen
the ‘bus’ dot parameter must be set to 1.
Please refer to the MintMT help file for further details on CANopen, MintMT keywords and dot
parameters.
4.7.4 Baldor CAN
The NextMove ST must have the Baldor CAN firmware loaded to use this protocol.
Baldor CAN is a proprietary CAN protocol based on CAL. It supports only the following range
of Baldor CAN specific I/O nodes and operator panels:
H
InputNode 8 (Baldor part ION001-503) - an 8 x digital input CAN node.
H
OutputNode 8 (Baldor part ION003-503) - an 8 x digital output CAN node.
H
RelayNode 8 (Baldor part ION002-503) - an 8 x relay CAN node.
H
IoNode 24/24 (Baldor part ION004-503) - a 24 x digital input and 24 x digital output CAN
node.
H
KeypadNode (Baldor part KPD002-501) - an operator panel CAN node with 4 x 20 LCD
display and 27 key membrane labeled for control of 3 axes (X, Y, Z).
H
KeypadNode 4 (Baldor part KPD002-505 ) - an operator panel CAN node with 4 x 20 LCD
display and 41 key membrane labeled for control of 4 axes (1, 2, 3, 4).
A typical Baldor CAN network with a NextMove ST and a Baldor CAN operator panel is shown
in Figure 18.
RJ45 J1 / J2
Twisted pair
24V
0V
T
R
24V
0V
J3
Baldor CAN Operator Panel
Operator
Panel
supply
CAN-
CAN+
1
2
4
5
4
3
2
1
NextMove ST
1
2
4
5
JP3 T
R
JP1
Figure 24 - Baldor CAN operator panel connections
The NextMove ST CAN channel is opto-isolated, so a voltage in the range 12-24V must be
applied to pin 5 of the CAN connector. From this supply, an internal voltage regulator provides
the 5V required for the isolated CAN circuit. The required 12-24V can be sourced from the
Baldor CAN I/O node or operator panel’s supply, which is internally connected to the CAN
connector as shown in Figure 24.
On Baldor CAN I/O nodes and operator panels, jumpers JP1 and JP2 must be set to position
‘1’ (the lower position) for the network to operate correctly. This configures the node’s CAN