General Information 1-1
MN1917
LT0162A00 Copyright Baldor (c) 2002. All rights reserved.
This manual is copyrighted and all rights are reserved. This document or attached software may not, in whole or in part, be
copied or reproduced in any form without the prior written consent of Baldor.
Baldor makes no representations or warranties with respect to the contents hereof and specifically disclaims any implied
warranties of fitness for any particular purpose. The information in this document is subject to change without notice. Baldor
assumes no responsibility for any errors that may appear in this document.
Mint
t
is a registered trademark of Baldor.
Microsoft Excel, Windows 95, Windows 98, Windows ME, Windows NT, Windows XP and Windows 2000 are registered
trademarks of Microsoft Corporation.
UL and cUL are registered trademarks of Underwriters Laboratories.
Product notice
Only qualified personnel should attempt to operate or troubleshoot this equipment.
Safety Notice
Intended use: These units are intended solely for stationary ground based demonstration purposes. They are not intended for
use in industrial power installations. The connection and control of drives is a skilled operation, disassembly or repair must not
be attempted. In the event that a drive fails to operate correctly, contact the place of purchase for return instructions.
Precautions
WARNING
:
Do not touch any circuit board, power device or electrical connection before you first ensure that no high
voltage is present at this equipment or other equipment to which it is connected. Electrical shock can
cause serious or fatal injury. Only qualified personnel should attempt to start-up, program or troubleshoot
this equipment.
WARNING
:
Be sure that you are completely familiar with the safe operation and programming of this equipment. Only
qualified personnel should attempt to operate or troubleshoot this equipment.
WARNING
:
Be certain that unexpected motor movement will not cause injury to personnel.
WARNING
:
The motor circuit might have high voltages present whenever AC power is applied, even when the motor
is not moving. Electrical shock can cause serious or fatal injury.
CAUTION
:
Do not connect AC power to the drive terminals U, V and W. Connecting AC power to these terminals may
result in damage to the drive.
CAUTION
:
Violent jamming (stopping) of the motor during operation may damage the motor and drive.
1
General Information
1
Содержание Flex+DriveII
