Baldor Flex+DriveII, Руководство по эксплуатации

Страница: 19 / 42

Basic Demonstrations 4-5
MN1917
4.3.1 Testing Preset moves
In this demonstration digital inputs will be used to trigger preset moves.
1. At the bottom of the Presets window, ensure that the
Digital Inputs option is checked. This means the
digital inputs will be used to control the preset index,
not WorkBench v5.
The Use Trigger option must also be checked.
This means that a digital input (DIN7 in this example) will be used to trigger the preset move.
2. Confirm that the control panel input switches 0-7 are in the off (up) position.
3. Just above the Presets table, click Enable to allow preset moves.
4. On the control panel, a combination of digital inputs 0, 1, 2 and 3 is used to set the preset index. These
combinations are described in the table below:
Preset index
(Bit pattern sum)
Input switch 0
(Bit pattern value: 1)
Input switch 1
(Bit pattern value: 2)
Input switch 2
(Bit pattern value: 4)
Input switch 3
(Bit pattern value: 8)
0 0 0 0 0
1 1 0 0 0
2 0 1 0 0
3 1 1 0 0
4 0 0 1 0
5 1 0 1 0
6 0 1 1 0
7 1 1 1 0
8 0 0 0 1
9 1 0 0 1
10 0 1 0 1
11 1 1 0 1
12 0 0 1 1
13 1 0 1 1
14 0 1 1 1
15 1 1 1 1
Table 1 - Preset selection using digital inputs 0-3
For example, to select preset move 6, set input switches 1 and 2 to the on (down) position.
5. On the control panel, set input switch 7 to the on (down) position to trigger the preset move.
Preset move 6 will now be performed once.
6. To perform a different preset move, select it using input switches 0, 1, 2 and 3, then move input switch 7 from off
to on to trigger the new move.
Note: The choice of digital inputs used to select and trigger presets is configurable. In this demonstration, the
Mint program
Presets.mnt configured switches 0, 1, 2, 3 and 7.