Baldan DCF-CO, Инструкция по эксплуатации

Страница: 103 / 122

Instruction Manual
DCF-CO 103
ƒ
Maintenance
• Cares
01 - Before each work, check the condition of all pins and screws. Where necessary,
retighten or replace them.
02 - Movement speed should be carefully controlled according to the terrain’s conditions.
03 - The DCF-CO is used in several applications, requiring knowledge and attention in its
handling.
04 - Only local conditions can determine the best way to operate the DCF-CO .
05 - When assembling or disassembling parts of the
DCF-CO
, use appropriate methods and
tools.
06 - Carefully observe the lubrification intervals in the various lubrification points of the
DCF-CO . Respect the lubrification intervals.
07 - Always check if the parts have wears. If there is a need for replacement, always demand
Baldan original parts.
Proper and periodic maintenance are necessary to ensure the long life
of the DCF-CO.
IMPORTANT
• General cleaning
01 - When storing the DCF-CO , perform a general cleaning and wash it thoroughly with water
only. Make sure the paint has not worn out, if this has happened, apply a general coat and
protective oil and fully lubrificate the DCF-CO . Do not use burned oil or other abrasive.
02 - After the work, proceed as follows:
- Remove transmission chains and keep them immersed in oil until the next work.
03 - Completely lubrificate the DCF-CO . Check all moving parts of the DCF-CO , for wear and tear or
gaps, make the required adjustments or parts replacements, leaving the machine ready for the
next work.
04 - When the DCF-CO is not in use, clean any product residues remaining after use, such as
limestone, fertilizers, dirt, etc.
05 - Spray the entire DCF-CO with castor oil or preservative oil, never use burnt oil.
06 - Replace any damaged or missing stickers, especially warnings. Make everyone aware of
the importance and risks of accidents when instructions are not followed.
07 - Clean the cardan every 15 days or sooner if necessary.