Page 13
during filtration.
For 24 hour circulation systems
, the circ pump and the ozone generator (if installed)
run 24 hours. In hot environments, the circ pump may turn off for 30 minute periods,
except during filter cycles.
For non-24 hour circulation systems
, the circ pump and ozone generator (if
installed) run during filtration ( and may also run automatically at other times).
At the beginning of each filter cycle all other equipment will run briefly to purge the
plumbing.
Button Function
VS/GS5xxZ
VS/GS5xxSZ
VS/GS5xxDZ or
GL8000
Temp
Setting:
Note:
After
three
seconds, the
display will
stop flashing
and begin to
display the
current spa
temperature.
Press "Temp" button once to
display the set temperature.
Press this button a second
time before the display stops
flashing. Each press of the
button will continue to either
raise or lower the set
temperature. If the opposite
direction is desired, allow the
display to revert to the
current water temperature
and done as above.
Press "Warm" or
"Cool" button once to
display the set
temperature. press a
temperature button
again before the
display stops flashing.
Press "Warm" or "Cool"
button once to display the
set temperature. press a
temperature button again
before the display stops
flashing.
Mode
Setting
Press "Temp", then press
"Light" button.
Press
"Warm"
or
"Cool", then press
"Mode" button.
Press "Warm" or "Cool",
then press "Mode" button.
Filter
Cycles
Setting:
Press "Temp" button, then
"Jets" button. Press "Temp"
button to adjust. Press "Jets"
button
to
exit
the
programming mode.
Press
"Warm"
or
"Cool" button, then
"Jets1" button. Press
"Warm" or "Cool"
button
to
adjust.
Press “Time”, “Mode/Prog”,
“Mode/Prog”, “Mode/Prog”
within 3 seconds.
“SET
START FILTER 1
” appear.
Press “Up” or “Down” to
