Page 12
(GL8000 system only):
Press “Jets 1” while in Economy mode puts the spa in
Standard-In-Economy mode
,
Which operates the same as Standard Mode, then reverts to Economy Mode
automatically after 1 hour. Both the “STANDARD” and “ECONOMY” icons display in
this mode. During this time, a press of the “Mode/Prog” button will revert to Economy
Mode immediately.
Sleep Mode
heats the spa to within 20°F/10°C of the set temperature only during filter
cycles. "
SL
" or "
SLP
" will display when water temperature is not current, and will
alternate with water temperature when the pump is running.
Standby Mode(GL8000 system only)
Pressing “Warm” or “Cool” then “Jets 2” will turn off spa functions temporarily. This is
helpful when changing a filter. Pressing any button resets the spa. Or system will
revert to previous mode after 1 hour.
Preset Filter Cycles
(For
VS/GS5xxZ and VS/GS5xxSZ
series only)
The first preset filter cycle begins 6 minutes after the spa is powered up. The second
preset filter cycle begins 12 hours later. Filter duration is programmable for 2, 4, 6, or
8 hours or for continuous filtration (indicated by "
FC
" or "
F1LC
"). The default filter time
is 4 hours for circulation systems.
For circulation systems, the circ pump and the ozone generator run 24 hours. In hot
environments, the circ pump may turn off for 30 minute periods, except during filter
cycles. At the beginning of each filter cycle all other equipment will run briefly to purge
the plumbing.
(For
VS/GS5xxDZ
series or GL8000)
The first preset filter cycle starts at 8:00 AM and ends at 10:00 AM. The second preset
filter cycle starts at 8:00 PM and ends at 10:00 PM.
For non-circ systems
, low-speed pump 1 and the ozone generator (if installed) run
