Balanced Body Allegro 2 Reformer, Руководство по сборке

Страница: 23 / 164

Installing the Tower on the Allegro® 2
PARTS LIST
Description Part Number Qty.
Tower frame 617-061 1
Tower receiver brackets (1 pair) 950-171 1
Lower spring mounts (1 pair) 950-170 1
Push-through bar 617-064 1
T-pins GEN9892 2
SoftTouch Single Loops 101-033 1 pair
Roll Down Bar 701-010 1
Square Bumper 206-002 3
Springs:
Long Yellow Trap Spring SPR9006 2
Long Purple Trap Spring SPR9461 2
Short Yellow Trap Spring SPR9002 2
Short Blue Trap Spring SPR9004 2
Safety Strap w/ Carabiner 210-023 1
TOOLS
Wrench 617-060 1
1. REMOVE HEAD-END OF FRAME
Note : Two people are recommended for this process.
» Lift the head-end (the end
with the risers on it) of
the Reformer and place a
sitting box or some other
solid object underneath
the frame rails so that the
head-end is off the ground.
This will support the rest
of the Reformer when the
frame end is removed.
» Remove the two nuts at the
head-end of the frame rails
with the included wrench as
shown in Figure A.
» Repeat on other side.
» Grab a riser and a leg
casting and pull the head-
end off the frame as shown
In Figure B. TIP: Some effort
will be required and rocking
the head-end from side to
side may help to loosen it
up.
» Remove the two black bumpers near the bolt holes on the
end casting and discard. If your reformer does not have them,
proceed to the next step.
2. INSTALL TOWER RECEIVERS
Take the Tower receiver brackets (they are attached to the Tower
for shipping purposes) and align them with the bolts at the end
of the frame rails. The bracket will be sandwiched between the
end of the frame rails and the head-end of the frame that was
just removed, as shown in Figure C.
Figure A (shown from underside of
Reformer)
Remove these
two nuts
Figure B
Figure C
Receiver brackets