Balance 275947, Руководство пользователя

Страница: 7 / 36

must press and hold [CH] button for 2 seconds to re-enter sensor
searching mode and repeat above steps if he wants to register a new
remote sensor.
REMOTE CHANNEL AUTO-SCROLLING
This device is equipped with an Auto-scroll function. While the Auto-scroll
function is set, the main unit will automatically cycle to display the indoor
temperature and the temperature of each remote sensor for 4 seconds.
1. To manually retrieve the specific sensor temperature reading, press
[CH] key until desired channel number is displayed.
2. To enable Auto-scroll function, use [CH] button to select channel #1,
#2, ... until auto scroll icon appears beside the channel indicator.
DCF-77 RADIO CONTROLLED CLOCK
The radio-controlled time is calculated by the Cesium Atomic clock of
Braunschweig (official clock of Germany). Then the time is coded and
transmitted from Mainflingen - near Frankfurt - via a signal on DCF-77 (77.5
kHz). The transmitting range of the signal is 1500 km, which means that
most of Western and Central Europe is covered by this signal. Within this
range the received time is completely accurate. Once sensor signal(s) are
received, the wave icon will flash to indicate that the receiving unit starts to
receive the DCF radio controlled time signal. Radio Controlled wave icon
indicates 4 levels of signal status:
Very weak Weak Mediu Strong
As soon as the time signal is received, the wave icon will stay on the LCD,
and time and calendar will automatically be updated.
Note: During the 10-minute time signal reception, all manual key input will
be ignored. In addition, the continuous mood light or Alert light will be turn
off temporary until reception is over. You can also press and hold
[ ▲ ] key
for 2 seconds to manually activate the reception in normal mode.
SET THE CLOCK, CALENDAR & TEMPERATURE UNIT
1. Press & hold [MODE] button for 2 seconds to enter clock setting mode.
Flashing 24Hr will appear.
2. Press [▲] or [▼] button to switch between 24Hr and 12Hr format, and
then press [MODE] button to confirm.
~ 7 ~
(EN)