Bakers Pride EP series, Руководство по эксплуатации

Страница: 3 / 22

FLOOR MODEL ELECTRIC DECK OVEN OPERATION MANUAL
1
TABLE OF CONTENTS
INSTALLATION INSTRUCTIONS 1
RECEIVING 1
LOCATION AND MINIMUM CLEARANCES
1
INSTALLATION 1
STACKING 3
STEAM OPTION
3
INSTALLATION OF DECKS 4
ELECTRICAL CONNECTION 5
SYSTEM CHECK 6
INITIAL START-UP 6
OPERATING INSTRUCTIONS 7
GENERAL BAKING 7
GENERAL BAKING TIPS 7
SPECIAL FEATURES 8
CLEANING 8
SERVICE AND TROUBLESHOOTING
9
SERVICE AND TROUBLESHOOTING CHART 10
RATING PLATE 10
PARTS LIST W/EXPLODED VIEW 11
WIRING DIAGRAMS 13
WARRANTY 19
Models Covered
Model Elements
Per Deck
Total Kw
Per deck
Phase Model Elements
Per Deck
Total Kw
Per deck
Phase
EP1(2,3)-8-3836 8 8 1 or 3 EB1(2,3)-8-5736 12 12 1 or 3
EP1(2,3)-8-5736 12 12 1 or 3 ER1(2,3)-12-3836 8 8 1 or 3
EB1(2,3)-8-3836 8 8 1 or 3 ER1(2,3)-12-5736 12 12 1 or 3
INSTALLATION INSTRUCTIONS
Receiving
Read the notice on the outside carton regarding damage
in transit. “CONCEALED DAMAGE”, damage discovered
after opening the crate(s), must be reported immediately
to the carrier. The carrier will perform an inspection of
the damage and furnish forms for the consignee’s claim
against the carrier. Retain all packing material- including
outer carton until the inspection has been completed.
Location And Minimum Clearances
Adequate air space must be provided for proper venting
of the controls and provisions must be made for venting
of the cooking vapors. The Oven must be installed in a
well-ventilated area and following minimum clearances
must be maintained at all times:
Ovens can be installed with “Zero” clearances (back
and sides) from combustible and non-combustible
materials.
The Ovens may be installed on combustible Flooring if
mounted on the Legs provided. Keep the area around
your oven free and clear of all combustible materials.
Installation
Place the oven and parts as close to the area of final
installation before un-crating. Your oven is packed
sitting on its back. Leave it on its back while unpacking.
The pallet may be left under oven for convenience in
further handling. Unpack carefully to avoid damage to
the oven. If concealed damage is discovered, follow the
instructions detailed in Receiving section above.
a) Legs are shipped in a separate carton complete
with mounting bolts and washers. Firmly bolt two
legs (in case of casters, the two with the brakes
must be used here) to the upper two corners
(front) of the oven as it rests on the pallet. Note:
(See Fig. 1).
b) Using sufficient help, tilt the oven forward and
lower it down so that the two front legs come to
rest on the floor. (See Fig.2)