7. STEAM INJECTION OPTION
The solenoid valve for steam injection is mounted behind the service panel on the right hand side of
the unit on COC-E and on the back of the unit on CO11-E. It is pre-wired at the factory. The
electronic timer is pre-set at the factory.
A ¼” copper tubing with a compression fitting for water connection is provided on the solenoid valve. Be
sure to check for leaks after installation.
6
OPERATING INSTRUCTIONS
1. GENERAL INSTRUCTIONS
a. This equipment has an electronic temperature control.
b. Due to increased efficiency of this oven, the temperature required for standard recipes may be
reduced by 50°F (30°C).
c. Always load each shelf evenly and space pans away from each other and the back and
sides of oven to allow for maximum airflow around the product.
d. Large tempered glass window(s) and interior light(s) allow for a close check of the product
making it unnecessary to open the door(s) too frequently.
e. Products cook faster in a convection oven as compared to a conventional oven, therefore,
depending upon the product and type of pans used, time saving may range anywhere from
20% to 50%.
2. SYSTEM OPERATING SEQUENCE
1. Cook Only Rotary Control
a. Close the oven door(s).
b. Turn selector switch to “High” or “Low” position. The green indicator light near the selector
switch will be illuminated.
c. Turn the thermostat knob to the desired cooking temperature.
d. Upon reaching the set temperature, the amber indicator light near the thermostat will turn off.
e. Load the oven with the product to be cooked.
f.
Remove the product from the oven when done.
2.
Timed Cooking Rotary Control
a. Close the oven door(s).
b. Turn selector switch to “High” or “Low” position. The green indicator light near the selector
switch will be illuminated.
c. Turn the thermostat knob to the desired cooking temperature.
d. Upon reaching the set temperature, the amber indicator light near the thermostat will turn off.
e. Load the oven with the product to be cooked.
f.
Turn the timer knob to the desired bake time and timer will begin counting down.
g. When the timer reaches zero, a buzzer will sound.
h. Turn the timer knob to “0” position.
!
!
NOTE:
The timer does not control the oven. It is only a reminder that the set
time has elapsed.
3. Cook & Hold Rotary Control
a. Close the oven door(s).
b. Turn selector switch to “High” or “Low” position. The green indicator light near the selector
switch will be illuminated.
c. Turn the thermostat knob to the desired cooking temperature.
d. Upon reaching the set temperature, the amber indicator light near the thermostat will turn off.