INTRODUCTION
I-E96-313A
3 - 1
SECTION 3 - INSTALLATION
INTRODUCTION
This section explains what you must do before you put the Dig-
ital Slave Output module (IMDSO04) into operation.
DO NOT
PROCEED
with operation until you read, understand and do
the steps in the order in which they appear.
NOTE: Refer to Product Instruction I-E93-911 for termination device
wiring instructions.
SPECIAL HANDLING
NOTE: Always use Bailey's Field Static Kit (P/N 1948385A2 - con-
sists of wrist strap, ground cord assembly, alligator clip) when work-
ing with modules. The kit is designed to connect a technician and
the static dissipative work surface to the same ground point to pre-
vent damage to the modules by electrostatic discharge.
The Digital Slave Output (DSO) module uses electrostatic sen-
sitive devices. Follow Steps 1 through 4 when handling:
1. Keep the module in its special anti-static bag until you are
ready to install it in the system. Save the bag for future use.
2. Ground the anti-static bag before opening.
3. Verify that all devices connected to the module are properly
grounded before using them.
4. Avoid touching the circuitry when handling the module.
UNPACKING AND INSPECTION
1. Examine the hardware immediately to verify it has not been
damaged in transit.
2. Notify the nearest Bailey Controls Sales Office of any such
damage.
3. File a claim for any damage with the transportation com-
pany that handled the shipment.
4. Use the original packing material and container to store the
hardware.
5. Store the hardware in an environment of good air quality,
free from temperature and moisture extremes.
