INSTALLATION
WIRING CONNECTIONS AND CABLING
I-E96-313A
3 - 5
5.
Push and turn the two captive retaining screws on the
module faceplate one half turn to the latched position. It is
latched when the slots on the screws are vertical and the open
ends face the center of the module. (To remove the module,
turn the module retaining screws to the unlatched position
and gently slide it out).
WIRING CONNECTIONS AND CABLING
The DSO has three card edge connectors to supply logic power,
establish slave expander bus communication and provide digi-
tal outputs (P1, P2, P3 respectively).
Wiring
Installing the module in the MMU connects the slave module to
the logic power (+5 VDC), necessary to drive the circuitry, at
P1. It also connects P2 to the slave expander bus for communi-
cation with the master module. P1 and P2 connection require
no additional wiring or cabling.
NOTE: You must install a dipshunt on the backplane of the MMU to
connect the slave expander bus between the slave module and
master module. Locate the modules so the bus can connect the
modules or they will not communicate.
Cable Connections
The IMDSO04 uses either a NTDI01 or NIDI01 for termination.
See Figure
to determine the cables to use with the TU/TM
you are using.
FUSING
The DSO does not have any on board fusing requirements.
PRE-OPERATING ADJUSTMENTS
You do not have to make any adjustments to the DSO prior to
operating.
