Waste Level
*Also see “User Settings” –> “Waste High” for
associated alarm*.
*Also see “Icons” section for associated icon*.
The level in the waste water tank is
displayed as a % on this screen.
Fill Internal Tank?
With the external pump connected to the
inlet and to an external water source,
press to fill the internal tank.
*Note: When the internal tank is full the pump
will stop automatically.*
External Temperature
The outside temperature, as detected by
a sensor underneath the van, is displayed
on this screen.
You can change between degrees Celsius and
degrees Fahrenheit by pressing
and
selecting
for °C or
for °F.
Internal Temperature
The inside temperature, as detected
by a sensor inside the control panel, is
displayed on this screen.
You can change between degrees Celsius
and degrees Fahrenheit by pressing
and selecting
for °C or
for °F.
Select Battery
*Also see “Icons” section for associated icon*.
With 230V mains disconnected, the
user can choose to draw power from
the leisure battery OR the vehicle
battery.
Press
to swap between batteries.
If the “Auto-Battery” feature is enabled (see
“User Settings” section) the system will
automatically switch to “Vehicle Battery” if
the “Leisure Battery Voltage” is low (less than
11V).
*Note: When 230V mains is connected “Leisure
Battery” is automatically selected and cannot
be changed.*
Leisure Battery Amps
*Also see “User Settings” –> “Amps High” for
associated alarm*.
*Also see “Icons” section for associated icon*
The current being drawn from your
leisure battery, in amps, is displayed on
this screen. A higher current will drain
your battery faster.
To display current draw as a % of maximum
recommended current press
then
Note: (0A = 0%) (12A = 100%)*/
You can return to displaying in Amps by
pressing
then
.
Leisure Battery Voltage and Vehicle Battery
Voltage
*Also see “User Settings” –> “Low Volts V” for
associated alarm*.
*Also see “User Settings” –> “Low Volts L” for
associated alarm*.
*Also see “Icons” section for associated icons*.
With 230V mains disconnected, this
screen shows the voltage of the currently
selected battery (set on “Select Battery”
screen).
An estimate of your batteries’ remaining
charge can be seen by pressing
then
.
*Note: (12V = 0%) (12.7V = 100%)*.
You can return to displaying in volts by
pressing
then
.
*Note: To increase accuracy of the voltage
reading, switch the “Master Switch” off.
*Note: The “Leisure Battery Voltage” actually
displays the voltage of the charger while 230V
mains is connected*.
*Note: “Vehicle Battery Voltage” cannot be
displayed while 230V mains is connected.
User Settings
Press
to access the “User Settings”
screen. See below for a description of
each option.
Navigation
• You can scroll through the settings with the
and
buttons.
• To edit a setting, highlight it by pressing
• When it is highlighted press
or
to change value.
• Press
to accept new value.
44
FITTED EQUIPMENT – The Control Panel
Содержание Approach
