Operating Instructions
Start Up
• Open cylinder valve (no 1).
• Firmly press the hose rupture protection
(green button no. 2) on the high pressure
hose.
• If necessary (e.g. after a new installation or
after inadvertently striking the gas cylinder
against the gas pressure regulation
system), hold the reset button (no. 3) in for
at least 5 seconds before slowly releasing
the green button (crash sensor triggering
element reset) on the MonoControl CS.
Some cylinder valves differ including
products fitted with push-on
connectors or something similar.
i
Changing the LPG Cylinder
Please use the included spanner to attach
and remove the high pressure hose from the
cylinder. It will help to generate the necessary
tightening torque and will prevent damage to
the screw fixings by over-tightening.
Residual gas: do not smoke, avoid open
flames.
• Close the empty gas cylinder’s valve.
• Remove the high pressure hose from the
gas cylinder.
• Attach the high pressure hose to the full
gas cylinder.
• Open the full cylinder’s valve.
• Press the hose rupture protection.
At any time after making changes, check the
hose connection to the cylinder valve for leaks
using a leak detector spray or a soapy solution.
Hose Change
Residual gas: do not smoke, avoid open flames.
• Close gas cylinder valve.
• Remove the high pressure hose from the
gas cylinder and from the regulator inlet.
!
When performing a hose change please
ensure that the O-ring provided with
the hose is correctly installed and not
damaged.
• Screw country-specific high pressure hose
to MonoControl CS inlet and to the cylinder.
• Open gas cylinder.
• Press the hose rupture protection and, if
necessary, the reset button.
• Check hose connection to cylinder valve
and at MonoControl CS inlet for leaks after
every modification.
i
We recommend that the gasket (part
number 50020-76300) is replaced
with every hose change. This will be
provided by your supplying dealer
upon replacement of the hose.
Gas Leaks
If a smell of gas becomes apparent, the
supply should be turned off at the cylinder
immediately. Extinguish naked lights including
cigarettes and pipes. Do not operate electrical
switches. Open all doors and windows to
disperse any gas escape. Butane/propane
gas is heavier than air; any escaping gas will
therefore collect at a low level. The strong
unpleasant smell of gas will enable the general
area of the leak to be detected. Check that the
gas is not escaping from an unlit appliance.
Never check for leaks with a naked flame; leak
investigation should be carried out using a leak
detector spray or soapy solution.
Do not operate any electrical apparatus
whatsoever, especially light switches. If the
leak is not obvious, the motorhome should be
evacuated and a competent service engineer
consulted. Avoid naked lights when connecting
or changing a cylinder. Ensure the gas valve
is turned off. Regularly inspect the flexible
gas hoses for deterioration and renew as
necessary with approved type (all hoses should
be replaced every five years).
Keep gas cylinders outside (and protected
against frost). If they must be kept inside make
37
5
C
ONNE
C
TION OF SER
VICE
S
- T
he Gas S
y
st
em
CONNECTION OF SERVICES – The Gas System
!
1
2
3
Содержание Approach
