Bailey Approach SE, Руководство пользователя

Страница: 36 / 96

6-3
CONNECTION OF SERVICES
2. Using the Whale Submersible Pump
(When a drinking water tap is not at
hand).
• Fill a suitable water container, and place
below the Whale Watermaster socket.
• Place the Whale Submersible pump into
the water container; the pump should
reach the bottom of the container.
• Lift the lid of the external Whale
Watermaster socket.
• Insert the Whale Submersible pump plug
firmly into the socket, and close the lid
down [approximately 90º] until it locates
and locks the Whale Submersible pump
plug into place.
• The pump will then start automatically to
fill the onboard tank.
• When the tank is full, the pump will turn
off.
Please note that when the water
container is empty the pump will
continue to run and will eventually burn out.
To remove the Whale submersible pump
• Lift the lid of the Whale Watermaster
socket, to the vertical position.
• Remove the Whale Submersible pump
plug from the Whale Watermaster socket.
• Close the lid of the Whale Watermaster
socket, until it is located into position.
Stow away the Whale Submersible pump in a
clean chemical free area, shaking any loose
water from the unit first.
It should be noted that as the container
volume is likely to be less than that of
the onboard tank, it is advisable to remain in
attendance, when filling the tank, as the life
of the pump will be drastically reduced if
allowed to run dry. To fill an onboard tank to
the brim you normally have to repeat this
procedure several times.
Repeat the operations under the heading 2.
Using the Whale Submersible pump ,
removing the pump from the Watermaster
socket each time.
Using the Whale Smartflo Pressure Pump
The water system can be primed as follows,
after the onboard water tank has been filled.
• Switch on the ancillary power supply to
the pump at the main panel.
• Open one hot tap e.g. Kitchen sink.
• Water will flow from the open tap after filling
the water heater. This could take a few
minutes if the water heater was empty.
• When the water is flowing smoothly, close
the hot tap and open the cold tap to expel
any air left in the plumbing system, close
this tap when the water runs smoothly.
• The system is now ready for use.
• Repeat with all taps to expel any air in
the system.
• Remove the shower head and repeat
the above actions to dispel any air from
that as well.
Hints
• Should the motorhome be left unattended,
or when the water supply has been
allowed to empty, switch off the power
supply at the pump at the main panel to
avoid the pump running continuously.
• Should the flow rate from the taps be
reduced at any time, check the grit filter at
the side of the pump, and clean as
necessary.
Fig 2