Baileigh WL-1220VS, Руководство оператора

Страница: 21 / 52

18
18
INITIAL STARTUP
Once the setup is complete, test run your machine to make sure it runs properly and is ready for
regular operation. This procedure should be used when ever the machine has been moved,
repaired, out of service for and extended period of time, or when a new operator is becoming
familiar with the machine.
The initial startup is used to verify that:

The motor powers up and runs correctly, and

The safety disabling mechanism on the switch works correctly.
If, during the initial start up, you cannot easily locate the source of an unusual noise or vibration,
stop using the machine immediately until the source is found and corrected.
Testing the machine:
1. Make sure you have read the safety
instructions at the beginning of the manual and
that the machine is assembled, mounted, and
electrically connected properly.
2. Make sure all tools and objects used during
assembly and installation are cleared away
from the machine.
3. Connect the machine to the power source.
4. Rotate the variable speed knob (A)
counterclockwise to the slowest position.
5. Stand in front of the headstock at
arm’s reach
to the ON/OFF paddle switch (B) and lift the
switch to turn the machine ON.

When operating correctly, the machine runs smoothly with even pitched hum.

Investigate and correct strange or unusual noises or vibrations before operating the
machine further. Always disconnect the machine from power when investigating or
correcting potential problems.
6. Press down on the paddle switch (B) to turn the machine OFF.
WARNING:
Eye and face protection must always be worn whether there
is material mounted or not!
Fig 5
C
B
A
D