7
7
SAFETY PRECAUTIONS (cont.)
11.
Sanding Polishing.
Remove the
tool rest before
performing polishing or sanding operations.
12.
Keep work area clean.
Cluttered areas invite injuries.
13.
Overloading machine.
By overloading the machine you may cause injury from flying parts.
DO NOT
exceed the specified machine capacities.
14.
Material Removal Rate.
Attempting to remove too much material at once can cause the
piece part to fly out of the lathe causing
severe bodily injury.
15.
Dress appropriate.
DO NOT
wear loose fitting clothing or jewelry as they can be caught in
moving machine parts. Protective clothing and steel toe shoes are recommended when
using machinery. Wear a restrictive hair covering to contain long hair.
16.
Use eye and ear protection
. Always wear ISO approved impact safety goggles
17.
Turning Speed.
Select the correct turning speed for your work. Always allow the lathe to
reach full speed before beginning an operation.
18.
Use Sharp Tooling.
Keep chisels and other tooling properly sharpened and held firmly while
turning.
19.
Do not overreach
. Maintain proper footing and balance at all times.
DO NOT
reach over or
across a running machine.
20.
Stay alert
. Watch what you are doing and use common sense.
DO NOT
operate any tool or
machine when you are tired.
21.
Maintenance and Adjustments.
Before starting any inspection, adjustment, or maintenance
procedure
MAKE SURE
the lathe is
OFF
, has come to a complete stop, and the electrical
has been properly
LOCKED OUT
.
22.
Check for damaged parts
. Before using any tool or machine, carefully check any part that
appears damaged. Check for binding of moving parts that may affect proper machine
operation.
23.
Reducing Piece Part Vibration.
If the piece part vibrates while turning, immediately turn the
lathe
OFF
. Check that the piece part is properly centered and balanced. Trim off excess
waste to help balance the piece.
Make Sure
piece part is secured.
24.
Observe work area conditions
.
DO NOT
use machines or power tools in damp or wet
locations. Do not expose to rain. Keep work area well lighted.
DO NOT
use electrically
powered tools in the presence of flammable gases or liquids.
25.
DO NOT
bypass or defeat any safety interlock systems.
26. Keep visitors a safe distance from the work area.
Содержание WL-1220VS
