11
11
DO NOT REACH over shaper. There is danger of
kickback which can pull the hand back into the cutter.
Use push sticks to assist in pushing the work through.
See Figure 4.
A push block and/or a push stick must be used if the
workpieces is less than 5” (127mm) to prevent your
hands from getting too close to the saw blade. Push
block must be used to cut narrow workpieces and,
when necessary, to push the workpiece against the
fence, a push block can be easily made by the
operator.
INTENDED USE
Purpose of the machine
The machine enables semi-finished products made of wood or materials based on wood to
be milled with a vertical spindle.
The machine is designed for operation performed by one worker only.
The machine may not be handled by children and youngsters in any manner.
Workers’ qualifications
Only and expert skilled in the field of wood-machining or a worker instructed and trained by
such expert may operate the machine.
While working on the machine the operator must get familiar with these instructions and
comply with any safety rules, regulations and provisions in force in the respective country.
Содержание SS-2822
