8
8
11.
Stock Condition. ALWAYS
inspect stock for staples, nails, knots, and other imperfections
that could become projectiles or cause kickback resulting in serious bodily harm. Warped
stock should be run through a jointer before you run it through the shaper.
12.
Use eye and ear protection
. Always wear ISO approved impact safety goggles
13.
Do not overreach
. Maintain proper footing and balance at all times.
DO NOT
reach over or
across a running machine.
14.
Blind Cut When Possible.
Blind cuts keep the shaper cutter on the underside of the piece
part and provide a distance guard for the operator.
15.
Stay alert
. Watch what you are doing and use common sense.
DO NOT
operate any tool or
machine when you are tired.
16.
Check for damaged parts
. Before using any tool or machine, carefully check any part that
appears damaged. Check for binding of moving parts that may affect proper machine
operation.
17.
Sanding Direction. NEVER
sand pointed or tapered stock with the point facing the feed
direction, which could cause the piece part to be thrown from the machine.
18.
Observe work area conditions
.
DO NOT
use machines or power tools in damp or wet
locations. Do not expose to rain. Keep work area well lighted.
DO NOT
use electrically
powered tools in the presence of flammable gases or liquids.
19.
Depth of Cut. NEVER
remove too much material in one pass. Several light passes are safer
and produce a better finish on the piece part.
20.
Securing Nuts and Knobs. NEVER
operate the shaper without the second locking nut in
place over the spindle nut.
ALWAYS
make sure that the shaper cutters, fence, and spindle
elevator knob have been properly tightened before running the machine.
21.
DO NOT
bypass or defeat any safety interlock systems.
22. Know the location of the
ON - OFF
switch and the
“E”- STOP
button.
23. Keep visitors a safe distance from the work area.
24.
Keep children away
. Children must never be allowed in the work area.
DO NOT
let them
handle machines, tools, or extension cords.
25.
DO NOT operate machine if under the influence of alcohol or drugs
. Read warning
labels on prescriptions. If there is any doubt,
DO NOT
operate the machine.
26.
DO NOT
touch live electrical components or parts. Inspect power and control cables
periodically. Replace if damaged or bare wires are exposed.
Bare wiring can kill!
27.
Be Sure
all equipment is properly installed and grounded according to national, state, and
local codes. If machine is equipped with a three-prong plug, it should be plugged into a
three-hole electrical receptacle. If an adapter is used to accommodate a two-prong
receptacle, the adapter plug must be attached to a known ground. Never remove the third
prong.
Содержание SS-2822
