21
21
3. Lock the table lock (E). Each revolution of the handwheel (F) results in a 4mm up or down
movement of the table (C). A scale on the handwheel column indicates the amount of
handwheel rotation. A pointer (B) indicates the table position relative to the cutterhead on the
scale (A) located on the side of the cabinet.
Jointer Controls and Adjustments
Referring to Figure 6:
Outfeed Table Height Adjustment
1. Lock knob (C) and lifting handle (B) control the height
adjustment of the outfeed table (A). The outfeed table is
initially adjusted at the factory and should not be
repositioned except during certain adjustments.
Infeed Table Height Adjustment
Lock knob (D) and lifting handle (E) control the height
adjustment of the infeed table (F).
To adjust:
1. Loosen lock knob (D).
2. Raise the lifting handle (E) to raise the infeed table for a
shallow depth of cut. Lower the handle for a deeper cut.
3. Tighten the lock knob (D).
Note: A dept
h of cut of 0.0625” (1.5mm) or less is recommended.
Cutterhead Guard
1. Properly positioned, the cutterhead guard (H)
should rest against the fence (A).
Fence Movement
Referring to Figure 7:
The fence (A) can be moved forward (B) or backward
(C) across the width (W) of the table. It also tilts up to
45 degrees backwards (D).
To slide fence forward or backward:
Note: When edge jointing, the fence
assembly should periodically be moved to different
positions to distribute wear on the cutterhead knives.
Figure 6
Figure 7
Содержание JP-1250-1.0
