27
27
5. Place a straight edge (D) across the front of the outfeed table (F) and extending over the
infeed table (G). Note the position of the infeed table (G).
Note: The position of the straight edge
as shown in figure 12 with respect to the fence (H).
6. Raise the infeed table (G) until it contacts the
straight edge (D).
The straight edge should lie level across both tables.
Move the straight edge to the back of the outfeed
table as shown in Figure 12 and perform the same
test.
If the straight edge does not lie level, the front or back
of one of the tables must be adjusted to make the
tables coplanar.
Performing the Coplanar Alignment
If alignment is required as determined in the previous section, proceed as follows:
1. Disconnect power from machine.
2. Unlock both cabinet lock handles (A2 Fig.13).
3. Raise the table (D) fully upright. Adjustment is performed by means of four setscrews (B2)
that adjusts the table pitch and tilt at the back (towards the fence) and two hex cap screws
(A1) that adjusts the table toward the front.
Adjustment can consist of a front adjustment, rear adjustment or (more probable) a combination
of both.
WARNING:
Make sure the electrical disconnect is OFF before working on
the machine.
Blades are extremely sharp! Use caution when cleaning or changing. Failure to
comply may cause serious injury!
Figure 12
Содержание JP-1250-1.0
