Bahco TEA003, Оригинальное руководство пользователя

Страница: 5 / 204

5
4. OPERATING INSTRUCTIONS
4.1 Measurement Screen
Changes the Units of Measurement
(N·m, lbf·ft and lbf·in etc.)
To enable/disable units, use the UNITS
MENU (Press and Hold)
Changes the Mode of Operation
(Track, Click and Dial)
To change Click Mode settings, use the
CLICK MENU (Press and Hold)
Changes the Selected Target
(T01 XXX.X, T02 XXX.X etc.)
Units are automatically changed to the
targets units.
NOTE: T-- ---- means Targets are OFF
To edit targets, use the TARGET MENU
(Press and Hold)
Resets a captured peak
In Dial Mode (and Click Mode if set to
Manual Reset)
Zeroes the reading
In Track Mode if reading <4% Full Scale
Deflection (FSD)
In Click and Dial Mode if reading <1%
FSD
3. SET UP INSTRUCTIONS
1. Identify a suitable surface and position to
mount the instrument.
2. Drill two mounting holes suitable for M10
fasteners (M10 Cap Screws of grade 12.9
minimum are recommended).
3. Recommended fastener torque of 35 to 40
N·m (25 to 30 lbf·ft).
4. After connecting the provided power supply
the instrument will be ready to use after
approximately 12 seconds.
WARNING: ENSURE THE
MOUNTING SURFACE IS
CAPABLE OF SUPPORTING THE
INSTRUMENT WHEN THE RATED
CAPACITY TORQUE IS APPLIED.
ONLY USE THE POWER SUPPLY PROVIDED.
DO NOT APPLY TORQUE ABOVE THE RATED
CAPACITY.
This tester is intended for testing torque tools
only.
Mode of Operation
Units of Measurement
Selected Target
Target Indicator Line