BAHAMA Jumbrella, Важная информация

Страница: 6 / 56

the LARGE-SIZE
parasol
5
4.4 Proceed to the periphery of the canopy to continue from outside. With your finger tips push two arm (rib) ends
further down and – at the same time, positively – wholly towards the major pole until you perceive an obvious
(yet soft) mechanical detent.
4.5 Very important now : Pull each of the 8 (10, or 12, nbrs. depending on
the very model) fabric sections wholly out of the frame corpus. Flatten
i.e. smooth these now quasi triangular sections by distinctly stretching
their centre pleats in one outwards and down at their lowermost/most
extreme ends, and wind the so prepleated membrane sections in o n
e sense all about the frame corpus – as illustrated schematically herein
right
! – Also, in this context, please observe ”Rule 5” per sub-para 4.8
more below !
4.6 Hold this wound-about ”package” in shape, attach the Bahama
Swiftbelt (buckle harness) a hand’s breadth above the lowermost ends
of arms, pull it reasonably (not sharply) tight, and press the clamping
buckle closed – as illustrated herein right. Should the triangular fabric
sections not lie flat and smoothly underneath the tightened Swiftbelt,
again flatten them by stretching outward. –
CAUTION: To strap the
closed umbrella package don’t use any wire, nor cord, nor any adhesive
tape material!
Should the respective umbrella come with more than
one Swiftbelt (this is the case with larger square and rectangular models
due to their different arm lengthes), all Swiftbelts have to be attached
in accordance with the original arrangement upon delivery.
4.7 Turn the (yet partly spread) left-hand tension latch down wholly: By doing so, the cam protruding from the
inward face of the latch must fully insert into its counter-port on the major pole – exception to this: the
Jumbrella XL models. Reinsert both cylinder locks into their empty ports in latches, lock them up, and pull keys
off – so to prevent the Jumbrella from getting unfolded by unauthorized persons.
4.8 In case you intend to refold and secure the Jumbrella for a longer term i.e for more than 1 to 2 weeks, and
provided the structure was orderered to come with its (optional) reusable, made-to-measure protective cover
(strongly recommended by the manufacturer):
[Using a free-standing safety step ladder to be placed across and close to the folded structure:]
4.81 Unscrew the (white) screw-ball/ crane eyelet in zenith to remove the cone-shaped cover from top of the
structure. It is recommended to store parts in a place that you’ll recall as you’ll need them again for
reunfolding the structure.
4.82 Pull the reusable protective cover over the top of the umbrella and, gradually, further down until it fits
the top of the corpus. Wind binding cords twice about the bottom surplus of the cover, tighten both ends
(to prevent vermin from getting inside), and tie them up thoroughly so that they cannot untie by
themselves.
Rule 5: Prior to closing & securing the umbrella for more than 2 days (48 hours) make sure its fabric
membrane is absolutely dry, not wet, humid or damp, nor just ”hand-dry” (risk of damp-stains) !
5.
Miscellaneous, Manufacturer’s General Recommendations, Warnings, etc.
5.1 Except for and during speedily unfolding and/or refolding the Jumbrella under zero- or low-wind conditions, it
must n e v e r b e k e p t in any intermediate or transit configuration between »UNFOLDED &
TENSIONED« and »(RE-) FOLDED & SECURED«!