Operating Manual BaehrTec S2000
Page 38/52
English– V101 – Status 07/2015
Only the appropriate tool should be used to clean Easy-Clean. Other types
and fields of application are carried out at your own risk, and may conceal
dangers. No form of misappropriation is permitted.
Improper use may lead to damage to persons or objects.
The manufacturer cannot be held responsible for any damage caused by
improper use, unqualified staff or incorrect operating.
All warranty claims are void following improper use.
The clamping mechanism cleaner must only be used only for Easy-Clean
(developed for self cleaning). With conventional clamping mechanisms which
are not intended for self cleaning,
under no circumstances
must the
clamping mechanism cleaner be used, as the clamping mechanism will
immediately suffer damage.
Clean the clamping device cleaner 1 after each use and make sure that it is
always in a perfect hygienic condition before use.
We recommend a brush (Art-No. 34916) to clean the clamping mechanism
cleaner 1.
For hygiene reasons, please clean the clamping mechanism cleaner 2 after
use under running water and then with alcohol.
The images are for illustrative purposes only. Subject to technical and optical
changes.
1x
Clamping device cleaner 1
Universal stainless steel
Art-No.: 40287
1x
Clamping device cleaner 2
(Cleaning brush for Easy-Clean)
Art-No.:
40269
To clean Easy-Clean, please proceed as follows:
1.
Turn off the device at the main switch and disconnect it from the power supply.
Never clean the device while the handpiece motor is still running! Risk of injury!
In addition, the clamping mechanism will suffer damage!
2.
Put on a disposable glove, or pull a finger cot over the thumb on the hand with which
you want to hold the handpiece while cleaning, and then hold the handpiece in this
hand.
3.
Now press on the top of the handpiece with your thumb. By holding the tip with the
disposable glove/finger cot, you prevent the tip from turning while cleaning (
see Fig.
17
).
4.
Insert the clamping mechanism cleaner 1 without pressure as far as possible into the
opening of your handpiece and turn the clamping mechanism cleaner 1, pressing
slightly to the left and right (
see Fig. 18
).
5.
Now pull out the clamping mechanism cleaner 1 from the opening. Next, remove the
dirt from the grooves on the clamping mechanism cleaner 1 with a small brush.
Repeat the cleaning process until you cannot remove any more dirt.
6.
After use, clean the clamping mechanism cleaner 1 with Baehr quick surface
disinfectant (Art-No. 11015).
7.
Now remove any final impurities with the clamping mechanism cleaner 2 by inserting it
as deep as possible into the opening on your handpiece and then turning to the left
and right (
see Fig. 19
).
8.
Now pull out the clamping mechanism cleaner 2 from the opening.
9.
Only clean the clamping mechanism cleaner 2 with water, then with Baehr quick
surface disinfectant (Art-No. 11015) and then with Baehr Alcohol (Art-No. 11032) to
degrease the tool.
