Operating Manual BaehrTec S2000
Page 32/52
English– V101 – Status 07/2015
reminds you that a different maximum instrument diameter must be used.
The instrument heads indicated on the front foil are intended to help you
identify the maximum speed for your instruments. However, before you work
with an instrument, be sure to follow the manufacturer’s instructions on the
permitted maximum speed. The maximum speed specified there must not be
exceeded under any circumstances. This poses a danger of injury and the
danger that your device will be damaged.
The maximum speed for the instrument currently in use must not be
exceeded.
Make sure that you do not block the handpiece motor by overloading it. This
may be the case, for example, if your instrument gets caught in something
(such as a towel) while working. If this happens, switch off your device as
soon as possible at the main switch or disconnect it from the mains as soon
as possible. As soon as the device is disconnected from the mains, remove
the blockage and check your device for damage (e.g. instrument or
handpiece damaged). Only reconnect the device to the mains and turn it on
again if you do not find any damage. Now check your device at a handpiece
rotation speed of 6,000 rpm with a small instrument (max. Ø 7 mm) and
carefully test the entire rotation speed range in steps. If you do not notice
anything here, you may continue your work carefully.
9.
With the push buttons
(22) – (27) and (28) or (29)
you can change the spray level.
The selected spray level is shown on the display.
10. The push button
(21)
switches the spray function to "not ready to use" in other words it
switches it off.
11. You can switch the handpiece light on and off using the button
(17)
. You can adjust
the light intensity in the options menu as already described.