OTEE:
N
1) The symbol
shows that the meter is in the transport mode
2) *The marked parameters are displayed only in the transport mode
3) **The marked parameters can also be changed in the normal operation mode
LCD Image
Parameter
Possibility to change
C: 0000000
INF
Subscriber number
Yes
SoFt 0 01
INF
Software version number
0000000
INF
Meter factory (serial) number
0000000 0
h
INF
Error-free meter operation time
b:0000000
h
INF
Total operation time of the meter
tESt on
Wh
INF
For activating the
Test Mode
and the output of
energy pulses through the optical interface
Yes**
m³
tESt on
INF
For activating the
Test Mode
and the output of
volume pulses through the optical interface
Yes**
InStALL
INF
For activating the RF interface installation
mode by the press-button (press and hold)
Yes**
Changing the Meter Configuration
The parameters marked in
“Procedure for Checking the Meter Configuration” on page 9
can be changed using the
configuration program HEAT3_service (or with buttons, if the meter is in transport mode) If the transport mode is turned off
in the meter, to change parameters (except type of energy measurement, measurement units and installation place), the slot
SERVICE should be opened at the back of the electronic unit by breaking the partition and to short-circuit the contacts inside
(TEST indication will turn on) By short-circuiting the contacts repeatedly, the configuring function will be turned off After
configuration, the slot must be sealed with a sticker seal
Installation Procedure
Page 12
November 2020
HYB-UM-03193-EN-02
