USE SEPARATE CABLE INLETS FOR CABLES CONNECTED TO THE SOLID-STATE RELAY OUTPUT AND CABLES CONNECTED
TO THE OTHER INPUT/OUTPUTS.
IN MULTIPHASE NETS, SOLID-STATE RELAY SHOULD HANDLE ONLY THE SAME PHASE THAT IS USED FOR POWERING
THE METER.
ATTENTION
UTILISEZ DES ENTRÉES DE CÂBLE DISTINCTES POUR LES CÂBLES BRANCHÉS À LA SORTIE DES RELAIS STATIQUES ET
AUX CÂBLES BRANCHÉS AUX AUTRES ENTRÉES OU SORTIES.
POUR LES FILETS MULTIPHASES, LE RELAIS STATIQUE NE DEVRAIT SERVIR QUE LA MÊME PHASE UTILISÉE POUR
ALIMENTER LE COMPTEUR
M1000 MAIN MENU PROGRAMMING OPTIONS
Screen Layout
The following M1000 programming options are available from the
Main Menu
:
•
Meter Setup
•
Measurement
•
Input/Outputs
•
Totals
•
Communications
•
Miscellaneous
•
Information
•
Pin
Meter Setup
Main Menu
Menu header
Scrollbar
Indicates a submenu
Submenu
Figure 24: Screen layout
Function Buttons
All M1000 programming is accomplished using the three function buttons located on the front
of the amplifier . Screen navigation, digit, and parameter selection is performed by pressing a
combination of these three buttons .
Press
to scroll through the menu screens or move downward in a list .
Press
or
EXIT SAVE
button to enter a menu or move to the next submenu . The scrollbar on the upper right shows your
position in the list . Press
EXIT SAVE
to go back from a submenu to the upper menu .
To select parameters or values from a list in a menu point, first press
until the parameter or value is displayed then press
EXIT SAVE
to select it . The current number in the list is marked by a little black square to the left of the number . For example,
DN 50 .
To change a parameter, press
to enter the menu . The first character flashes . Press
to change the value . Once you have
changed the value, press
to move to the next value . Press
EXIT SAVE
to confirm the new value .
Status Icons
Communication interface is activated
Meter is unlocked
Error message
Empty pipe detection
M1000 Main Menu Programming Options
Page 19
January 2018
MAG-UM-00379-EN-04