Outdoor LP Gas Barbecue Grill Model No. GBT1321WRS / BY13-101-001-06
Lighting Instructions
W
CAUTION: Keep outdoor gas cooking appliance area clear and free
from combustible materials, gasoline and other flammable vapors and
liquids.
W
CAUTION: Do not obstruct the flow of combustion and ventilation air.
W
CAUTION: Check and clean burner/venturi tubes for insects and insect
nests. A clogged tube can lead to a fire beneath the grill.
W
CAUTION: Attempting to light the burner with the lid closed may cause
an explosion.
1. Make sure all labels, packaging and protective films have been removed from the grill.
2. Open lid during lighing.
3. Make sure there are no obstructions of airflow to the gas unit. Spiders and insects can
nest within and clog the burner / venturi tube at the orifice.
4. Connect LP gas tank per “Connect LP Gas Tank” instructions.
5. The regulator/control knob must be in the “OFF ” position (Figure 2).
6. Turn the control knob to (HIGH).
7. Press the Igniter button repeatedly (3 to 4 times) to light burner.
8. If ignition does not occur in 5 seconds, turn regulator/control knob to “OFF ” position,
wait 5 minutes and repeat lighting procedure.
9. If igniter does not light burner, use a lit match to light burner manually. Access the burner
through the hole in bottom bowl as indicated (Figure 6).
10. Turn the regulator/control knob to (LOW) and position the lit match near side of the
burner.
11. After lighting, observe the burner flame. Make sure all burner ports are lit and flame height
matches illustration (Figure 7).
W
Caution: If burner flame goes out during operation, immediately turn
the regulator/control knob “OFF ” and open lid to let the gas clear
for 5 minutes before re-lighting.
Turning Off
1. Turn regulator/control knob to the “OFF ” position (Figure 2).
2. Disconnect LP gas tank per “Disconnect LP Gas Tank” instructions and properly store tank.
Cooking
W
CAUTION
: Do not leave grill unattended while preheating or burning off food
residue on
(HIGH)
. If grill has not been cleaned, a grease fire can occur.
1. Open lid and ignite burner per “Lighting Instructions.”
2. Close lid and preheat grill on (HIGH).
3. Adjust regulator/control knob to desired temperature.
4. Wearing protective gloves, lift lid by handle(s) and use long handle tongs to place food onto
cooking grids above the lit burners.
5. With lid open or closed, cook until desired internal food temperatures are achieved.
6. Turn grill “OFF” by turning regulator/control knob to the “OFF ” position. Remove LP gas
tank, per “Disconnect LP Gas Tank” instructions, and properly store tank.
Controlling Flare-ups
W
CAUTION: Putting out grease fires by closing the lid is not possible.
• If a grease fire develops, turn regulator/control knob
“OFF .” Do not use water on a grease fire. This can cause the
grease to splatter and could result in serious burns, bodily harm or
other damage.
• Do not leave grill unattended while preheating or burning off food
residue on (HIGH). If grill has not been cleaned, a grease fire can
occur that may damage the product.
W
WARNING: When cooking, fire extinguishing materials shall be readily
accessible. In the event of an oil/grease fire, do not attempt to
extinguish with water. Use type BC dry chemical fire extinguisher or
smother with dirt, sand or baking soda.
Flare-ups are a part of cooking meats on a grill, and adds to the unique flavor of grilling.
Excessive flare-ups can over cook your food and cause a dangerous situation for you
and your grill.
Important:
Excessive flare-ups result from the build-up of grease in the bottom of your grill.
If a grease fire occurs
, close the turn
AND
lid the regulator/control knob to “OFF ,” until the
grease burns out. Use caution when opening the lid as sudden flare-ups may occur.
If excessive flare-ups occur,
DO NOT
pour water onto the flames.
This grill is designed to operate with a one pound
7.75” or 10.6” high disposable / 16.4 oz. or 14.1 oz.
propane gas tank (DOT 39 Cylinder) (Figure 1)
DO NOT ATTEMPT TO REFILL ANY ONE POUND (16.4
oz. or 14.1 oz.) PROPANE GAS TANKS!
Connect LP Gas Tank
Only cylinders marked “propane” may be used.
Note
: Some 1-lb cylinders may form frost when near
empty.
1. Make sure the regulator/control knob is in the
“OFF ” position (Figure 2).
2. Lubricate the threads of the regulator/control
knob with petroleum jelly. Line up threads on LP
gas tank with regulator/control knob.
3. Insert and rotate LP gas tank clockwise until
they fit snugly together. HAND TIGHTEN ONLY. Be
careful not to cross threads when screwing in
canister
(Figure 3).
4. Test for leaks. See “Checking for Leaks” section.
Disconnect LP Gas Tank
1. Turn the regulator/control knob to the “OFF ”
position (Figure 2).
2. Rotate LP gas tank counterclockwise until it is
loose (Figure 4).
3. Store the LP gas tank in a proper location, per LP
gas tank instructions.
Checking for Leaks
Burner Connections
1. Make sure the regulator/control knob is securely
fastened to the burner.
Note: The brass nut should be 1/4 to 1/2 turn past
tight. The regulator will rotate 360º even when the
brass nut is tightened.
If your unit was assembled for you, visually check
the connection between the burner and regulator/
control knob (Figure 5).
W
WARNING: Failure to inspect this
connection or follow these instructions
could cause a fire or an explosion
which can cause death, serious bodily
injury or damage to property.
2. If the burner and regulator/control knob do not
fit properly or if you have any questions, please
contact 1.800.762.1142 for assistance.
Tank/Gas Line Connection
1. Make 2-3 oz. of leak solution by mixing one part
liquid dishwashing soap with three parts water.
2. Make sure regulator/control knob is in the
“OFF ” position (Figure 2).
3. Spoon several drops of solution, or use squirt
bottle, at all “X” locations (Figure 5).
a. If any bubbles appear remove the LP gas
tank and reconnect, making sure the
connection is secure.
b. If you continue to see bubbles after several
attempts, remove the LP gas tank per
“Disconnect LP Gas Tank” instructions, and
contact 1.800.762.1142 for assistance.
c. If no bubbles appear after one minute, wipe
away solution and proceed.
First Use
1. Make sure all labels, packaging and protective
films have been removed from the grill.
2. Remove manufacturing oils before cooking on this
grill for the first time by operating the grill for at
least 15 minutes on (HIGH) with the lid closed.
This will “heat clean” the internal parts and
dissipate odors.
Operating Instructions
Figure 1
1 lb
453 g
7.75 in.
/ 19,7 cm
3.875 in. / 9,8 cm
2.9 in. / 7,4 cm
1 lb
453 g
10.6 in.
/ 26,9 cm
Figure 2
OF
F
AP
AG
AD
O
Figure 3
Figure 4
Figure 5
X
X
Figure 6
Match
Figure 7
1/2"
12,7 mm
6,4 mm
0 mm
1/4"
0"
Flame
