Assembly
Phase 19
Hardware needed:
• (4) BP - SCREW PFH 8x1-1/2 - H100086
• (20) BQ - SCREW PFH 8x1-1/4 - H100087
Parts needed:
• (2) F1 - COUNTER SUPPORT - W101809
• (2) K6 - COUNTER SUPPORT - W101812
• (1) K1 - FRONT COUNTER BOARD - W101810
• (1) K2 - FRONT COUNTER BOARD - W101811
Phase Notes
• Assemble with hardware as shown.
Step 1: Attach 'F1'
Counter Support to
'WP1' & 'WP2' walls
using screws 'BP', as
shown.
Step 2: Attach 'K6' Counter
Support to 'K1' Front Counter
Board using screws 'BQ', as
shown.
Step 3: Attach 'K1' Front
Counter Boards 'F1' Counter
Support to using screws 'BQ',
as shown.
To prevent board splitting, you
must pre-drill each board with
a 1/8" drill bit, before attaching.
Note: Due to the changing size of the wood
as a result of moisture content, you may
need to adjust the spacing of your wall slats
1/16" to 1/8" when assembling walls. It would
be best to line up the boards on the wall
before attaching to estimate if a larger or
smaller gap is needed.
Note: Do not overtighten screws, overtightening
may cause the screw to stick through the boards
and may cause sharp points. The head of the
screw should NOT sink into the wood for this
phase, it should be flush.
BQ
BQ
F1
K6
WP2
K1
K2
BP
WP1
F1
BQ
Step 4: Attach 'K6' Counter
Supports to 'WP3' back wall
using screws 'BQ', as shown.
