Monoxor
Plus Manual
Operation
0019-9370 Rev 1
35
Step
Example Procedure for Taking Differential Temperature Measurements
8
At this point, you may press SAVE again to save the differential
temperature value to memory so that it can be retrieved and/or printed
later.
9
Carefully remove the probe assembly and allow it to cool.
NOTE:
A negative differential value will be displayed if T1<T2.
4.7. Timed Ambient CO Testing
This procedure takes approximately 15 minutes to complete and provides a
minute-by-minute snapshot of CO readings, as well as a “Max CO” value that
represents the highest CO reading measured during the entire 15-minute test.
Results can be saved to memory and/or printed. Use the optional CO
Appliance Kit (
P/N 0024-8555
) and the following procedure to perform an
ambient CO measurement.
Step
Example Procedure for Taking Ambient CO Measurements
1
Attach optional appliance kit probe (P/N 0024-8555) if required.
2
Turn on the Monoxor
Plus in a fresh air environment and wait for
initialization to complete.
3
Verify successful initialization (no errors).
4
Check battery status (see page 13). If battery life is questionable,
replace the batteries, as the Ambient CO test takes approximately
15 minutes to complete.
5
Move instrument to target location to be tested.
6
Press F2 to display the Main Menu.
7
Use the down arrow to highlight Ambient CO Test and press the
ENTER button.
8
Follow the on-screen instructions to initiate the test.
Refer to page 17 for details on navigating the ambient CO test
screens, viewing results, saving results to memory, and printing
results.
www.
GlobalTestSupply
.com
Find Quality Products Online at:
