Baby Lock Regalia BLRG20, Руководство по обслуживанию

Страница: 71 / 80

BabyLock.com
Page 71
1
2
3
4
6
8
5
9
10
11
12
7
Needle and Thread Information
Use the correct needle system (134) . Choose from sizes 12 through 21,
according to the type of thread used. A guide to help you choose the correct
combination of needle and threads is always available on the Regalia. From the
Home screen, tap the System Information button and choose the Needle and
Thread Guide button.
Quick Reference Card
To Thread the Regalia
Customize Handlebar Buttons
Select the Settings button, then select the
Handlebar button.*
Cycles the needle
up or down
Programmable
button
Starts or stops
stitching
Programmable
button
Increases or decreases
stitches per inch
(Regulated mode)
1. Place thread cone onto spool post (1), thread through thread-mast eyelet (2)
from back to front and pass through thread guide (3).
2. Continue to three-hole thread guide (4). Wrap all three holes from back to front,
being careful not to cross threads. If delicate threads are breaking,
skip one or two holes to lessen tension.
3. Pass through thread guide (5) and continue
down to tension assembly (6). Ensure
that the thread is flossed between
the two tension discs.
4. Catch the take-up spring (7) with
thread and pull it down under the
stirrup thread guide (8).
5. Bring the thread up and through the hole of the
take-up lever (9) from back to front, and then
through the lower thread guide (10). Finally, thread
through the needle bar thread guide hole (11).
6. Follow the groove down the front of the needle and
insert thread through the eye of the needle (12) from
front to back. While pulling thread through the eye, be
careful that the thread does not twist around the needle.
Increases or decreases
stitching speed (Manual
mode)
*Left/Right Swap should be determined before applying button membranes during setup.
1
2
3
4
6
8
5
9
10
11
12
7