Baby Lock Euphoria BLC4, Инструкция и справочник

Страница: 20 / 48

T
H
R
E
A
D
I
N
G
17
Chain Looper
1. With the presser foot in the raised position, open the front cover and move the threading lever into
the threading position, and rotate the handwheel counterclockwise until the looper tube locks into
position (see page 16, fig. A).
2. Place the thread cone or spool on the "Chain Looper" spool pin. Slip the thread into the telescopic
antenna thread guide above the thread cone.
3. Insert the thread through the hole of the thread guide above the chain looper tension dial from the
front of opening to the back. Bring the thread to the back under the thread guide, then up and
over the tension dial, making sure the thread is in the tension disk (fig. A inset).
4. Take the thread down to the chain looper threading port.
5. Pull 22 inches (55cm) of thread and insert 1/2 inch (1.2cm) of thread into the chain looper threading
port. Use tweezers if necessary to insert the thread end (fig. B).
6. Press the "Push to Thread Looper" button (fig. B). If the thread does not go through the eye of the
chain looper with one push, push the threading button again until it does.
7. Open side cover to the left for easy access to the chain looper thread in tray (fig. C).
8. Trim excess thread to 4 inches (10cm) from the eye of chain looper and lay thread back inside the
tray.
9. Close side cover.
10. Once machine is completely threaded for chosen stitching application, set the threading lever to
serging position.
͇
F
P
A B
C