Baby Lock Euphoria BLC4, Инструкция и справочник

Страница: 18 / 48

T
H
R
E
A
D
I
N
G
Threading Preparation
15
C
D
A
B
E
When using threads on cones or king spools, place the cone or spool
securely over the cone holders furnished on your machine. To avoid
bending the thread stand, you may need to place one hand under the
stand while positioning the cone. The cone holders prevent the cone
or spool from spinning, enabling the thread to feed evenly (fig. A).
Because threads for the Euphoria feed from the top, standard spool
threads can snag on the rough edges of many of these spools. The
spool caps furnished with your Euphoria will provide a smooth surface
for the thread to reel off the spools freely. With the spool notch side
down, insert a spool cap into the top of the spool (fig. B).
When using standard spool threads on your serger, replace the cone
holders with the sponge disks furnished with your machine. These
disks hold smaller spools securely and help the thread to reel off
properly. With the sponge disk in place, put the capped spool on the
spindle (fig. C).
Thread nets may be placed over threads that tend to slip off the
bottom of the spool during sewing. Most threads do not require their
use, but nets often are necessary with nylon, rayon or silk threads (fig.
D). Once it's on the spool, fold the net back on itself, if necessary, to
enable the thread to feed smoothly without snagging on the net (fig. E).
Front Cover Seam Guide
The distance between the first mark on the left
closest to the needle plate and each needle is:
C-1 needle: 1 inch (2.5cm), C-2 needle: 7/8 inch
(2.25cm), and C-3 needle: 3/4 inch (2cm).
This guide is great for hemming garments with cover
stitch.
1. Turn under hem and press.
2. Align the raw edge of the hem with the needles.
3. Align the folded edge of hem with the correct
guide mark.
There are marks on the bed of the Euphoria that can be used as a guides while sewing. It will
depend on what cover or chain stitch needle position you will be using as to what the width will be.