Baby Lock Altair 2, Инструкция и справочник

Страница: 92 / 212

UTILITY STITCHES
90

Odd Shaped Buttons/Buttons that Do Not Fit
into the Button Holder Plate
Add together the diameter and thickness of the button,
and then set the button holder plate to the calculated
length. (The distance between the markings on the presser
foot scale is 5 mm (approx. 3/16 inch).)
Example: For a button with a diameter of 15 mm (approx.
9/16 inch) and a thickness of 10 mm (approx. 3/8 inch),
the scale should be set at 25 mm (approx. 1 inch).
Four-Step Buttonholes
You can sew 4-step buttonholes using the following 4 stitches
together. You can sew any desired length for the buttonhole
when using 4-step buttonholes. 4-step buttonholes are a good
option when attaching oversize buttons.
Four-step buttonholes are sewn as shown below.
a
Mark the position and length of the buttonhole on the
fabric.
1
Starting point
2
End point
3
Buttonhole sewing
b
Attach advanced monogramming foot “N+”, and select
stitch to sew the left side of the buttonhole.
c
Press the “Start/Stop” button to start sewing.
d
Sew the desired length for the buttonhole and press the
“Start/Stop” button again.
e
Select stitch to sew the bar tack and press the
“Start/Stop” button.

The machine will automatically stop after sewing the
bar tack.
f
Select stitch to sew the right side of the
buttonhole, and press the “Start/Stop” button to begin
sewing.
g
Sew the right side of the buttonhole and press the
“Start/Stop” button again.
* Sew the right side of the buttonhole the same length
as the left.
1
Presser foot scale
2
Button holder plate
3
Combined
measurement of
di thickness
4
5 mm (approx. 3/16
inch)
Memo
• For details on stitch patterns, refer to “STITCH
SETTING CHART” on page 199.
Note
• When changing the stitch settings, make sure that
all stitch settings are changed to match.
a
b
c
d
1
10 mm (approx. 3/8
inch)
2
15 mm (approx. 9/16
inch)
b
c
a