Baby Lock Altair 2, Инструкция и справочник

Страница: 38 / 212

WINDING/INSTALLING THE BOBBIN
36
e
With your right hand, hold the thread near the thread
spool. With your left hand, hold the end of the thread,
and use both hands to pass the thread through the
thread guide.
1
Thread guide
f
Pass the thread around the pretension disk making sure
that the thread is under the pretension disk.
1
Pretension disk

Make sure that the thread passes under the
pretension disk.
2
Pretension disk
3
Pull it in as far as possible.

Check to make sure thread is securely set between
pretension disks.
g
Wind the thread clockwise around the bobbin 5 or 6
times, pass the thread through the guide slit in the
bobbin winder seat, and then pull the thread to cut it.
1
Guide slit in bobbin winder seat
(with built-in cutter)
• When using thread that winds off quickly, such as
transparent nylon thread or metallic thread, place
the spool net over the spool before placing the
spool of thread onto the spool pin.
If the spool net is too long, fold it to fit the size of
the spool.
1
Spool net
2
Thread spool
3
Spool pin
4
Spool cap
* When threading the spool with the spool net on,
make sure that 5-6cm (approx. 2 - 2-1/2 inches) of
thread is pulled out.
* It may be necessary to adjust the thread tension
when using the spool net.
a
Note
• Be sure to wind the thread clockwise around the
bobbin, otherwise the thread may become
wrapped around the bobbin winder shaft.
CAUTION
• Be sure to cut the thread as described. If the
bobbin is wound without cutting the thread
using the cutter built into the guide slit in the
bobbin winder seat, the thread may become
tangled in the bobbin or the needle may break
and cause injury when the bobbin thread starts
to run out.
a
b c
a